Microforms, Media, & Custom Copy

Smart Classroom Equipment Operation Instructions

Pull down screen in front of classroom. Open equipment lectern. Retrieve Sharp LCD Projector remote from inside lectern. Turn the Sharp LCD Projector remote face up. Press the ON button located at the top right corner on the remote to turn on the ceiling mounted Sharp Video/Data Projector. The red light on the bottom of the ceiling mounted projector should go off and a green light will turn on. It will take 20 to 30 seconds to fully power up the projector. Turn on the other data/audio/video components you will use by pressing individual power buttons to power up the VCR, DVD, JVC stereo receiver and/or the desktop computer stored in lectern. Slide out computer keyboard and mouse drawer. Use Input Select button on Sharp LCD Projector remote to choose visual input source to activate that projector function. Each time you press the input select button it cycles to the next visual input: Your Visual Input Source Remote Input Select Button Blank Input 1 Computer/Laptop Input 2 Blank Input 3 VCR Input 4 DVD Input 5 *DVD players are not installed in all smart classrooms.

7. Press the Power button on the JVC RX-6030 receiver to turn on the main power. Press the Source Select button (i.e. VCR, DVD, FM, CD, AM) to make your audio selection according to the table below. Receiver can also be operated using the JVC remote.
8. 
   

   
   

   

   
   

   PC	CD
   Laptop	TAPE/CDR
   VCR	VCR
   DVD	DVD
   FM Radio	FM
   AM Radio	AM
   The DVD MULTI and PHONO audio options are not connected, and should not be selected.

9. Adjust JVC Receiver volume levels to suit. Note: DO NOT PRESS "Speakers 2" button. It must be in the off position or speakers will not work. The "Speakers 1" button should be the only button in the ON position.